三菱功放模块 RA07H0608M

RA07H0608M是7-watt RF的MOSFET放大器模块为12.5-volt，在68-合作，88-MHz范围内的行动收音机.电池可以直接连接到漏极增强型MOSFET晶体管.如果没有门电压(VGG进排水=0V),只是一个很小的泄漏电流与输入信号衰减的RF高达60 dB.输出功率作为栅极和漏极电压增加电流增加.随着gate voltage around 4V (minimum), output power and drain current大幅增加.额定输出功率变为可在4.5V（典型值）和5V（最大）.在VGG=5V,典型栅极电流1 mA.该模块是专为非线性调频调制，但可能也可用于线性调制通过设置静态漏电流随栅极电压和输出功率控制输入功率.

特征
•增强型MOSFET晶体管(IDD≅0@ VDD=12.5V, VGG=0V)
• Pout>7W @ VDD=12.5V, VGG=5V, Pin=30mW
•ηT>38% @ Pout=7W (VGG控制），VDD=12.5V, Pin=30mW
•宽带频率范围：68-88MHz
•低功耗控制电流IGG=1mA (typ)在VGG=5V
•模块尺寸：30 x 10 x 5.4 mm
•线性操作有可能通过设置静态漏电流同门电压和输出功率的控制输入功率
RA07H0608M： Silicon RF Power Semiconductors RoHS Compliance ,68-88MHz 7W 12.5V, 2 Stage Amp. For PORTABLE RADIO
DESCRIPTION
The RA07H0608M is a 7-watt RF MOSFET Amplifier Module for 12.5-volt portable radios that operate in the 68- to 88-MHz range. The battery can be connected directly to the drain of the
enhancement-mode MOSFET transistors. Without the gate voltage (VGG=0V), only a small leakage current flows into the drain and the RF input signal attenuates up to 60 dB. The output power and drain current increase as the gate voltage increases. With a gate voltage around 4V (minimum), output power and drain current increases substantially. The nominal output power becomes available at 4.5V (typical) and 5V (maximum). At VGG=5V, the typical gate current is 1 mA. This module is designed for non-linear FM modulation, but may also be used for linear modulation by setting the drain quiescent current with the gate voltage and controlling the output power with the input power.

FEATURES
• Enhancement-Mode MOSFET Transistors VDD=12.5V, VGG=0V)
• Pout>7W @ VDD=12.5V, VGG=5V, Pin=30mW
• hT>38% @ Pout=7W (VGG control), VDD=12.5V, Pin=30mW
• Broadband Frequency Range: 68-88MHz
• Low-Power Control Current IGG=1mA (typ) at VGG=5V
• Module Size: 30 x 10 x 5.4 mm
• Linear operation is possible by setting the quiescent drain current with the gate voltage and controlling the output power with the input power RoHS COMPLIANT
• RA07H0608M-101 is a RoHS compliant products.
• RoHS compliance is indicate by the letter “G” after the Lot Marking.
• This product include the lead in the Glass of electronic parts and the lead in electronic Ceramic parts.How ever, it applicable to the following exceptions of RoHS Directions.
1.Lead in the Glass of a cathode-ray tube, electronic parts, andfluorescent tubes.
2.Lead in electronic Ceramic parts.
ORDERING INFORMATION:
ORDER NUMBER： RA07H0608M-101
SUPPLY FORM： Antistatic tray,50 modules/tray